id | field name | definition |
0 | Ip_Mie_1 |
ascii uint8 |
Left pixel defininig the Mie virtual channel on the ACCD (not counting the leading 2 pixels)
unit: "Pixels"
|
|
1 | Ip_Mie_2 |
ascii uint8 |
Right pixel defininig the Mie virtual channel on the ACCD (not counting the leading 2 pixels)
unit: "Pixels"
|
|
2 | Cal_Fit_Order |
ascii uint8 |
Order of polynomical to use in the Rayleigh signal fitting procedure in the calibration routine
|
|
3 | Cal_Z_Min |
ascii double |
Minimum altitude to consider [m] for calibration procedure
unit: "m"
|
|
4 | Cal_Z_Max |
ascii double |
Maximum altitude to consider [m] for calibration procedure
unit: "m"
|
|
5 | Cal_R_Min |
ascii double |
Minimum scattering ratio to consider for calibration procedure
|
|
6 | Cal_R_Max |
ascii double |
Maximum scattering ratio to consider for calibration procedure
|
|
7 | Cal_Std_Dev_Fit_Limit |
ascii double |
Number of standard deviations away from the mean to allow when fitting the lidar calibration coefficient with observation.
|
|
8 | Cal_Min_Number_Of_Points |
ascii uint16 |
Minimum number of points required to determine the lidar calibration constants.
|
|
9 | Cal_Number_Of_Wrap_Points |
ascii uint16 |
Number of wrap around points to use in the fitting procedure.
|
|
10 | Apply_Dynamic_EMSR |
ascii uint8 |
If set to 1, then determine EMSR (TOBS replacement) using clear-sky values and apply that instead of the values in the L1b input
|
|
11 | Z_Trop_Lower |
ascii double |
Lower limit for tropopause search
unit: "m"
|
|
12 | Z_Trop_Upper |
ascii double |
Upper limit for tropopause search
unit: "m"
|
|
13 | Dz_Above_Trop_EMSR |
ascii double |
Seach window exclusion-zone above trop level for dynamic EMSR determination
unit: "m"
|
|
14 | Dz_Below_Trop_EMSR |
ascii double |
Seach window below trop level for dynamic EMSR determination
unit: "m"
|
|
15 | Z_Min_EMSR |
ascii double |
Minimum altitude for dynamic EMSR determination
unit: "m"
|
|
16 | R_Thresh_EMSR |
ascii double |
Effective R threshold to be used to determine clear-air EMSR
|
|
17 | Apply_Excess_Noise_Factor |
ascii uint8 |
If set to 1, then apply the in-situ extimated excess noise factor in the noise calculations, if set to 0 then fix excess_noise_factor_per_pixel to 1
|
|
18 | Detect_Missed_Hot_Pixels |
ascii uint8 |
If set to one then try to detect and correct for missed Hot Pixels
|
|
19 | Hp_Half_Window |
ascii double |
1/2 window size to use in hot-pixel line detection
unit: "Pixels"
|
|
20 | Hp_Line_Test_Thresh |
ascii double |
Threhold to use for line detection in HP detection routine
unit: "LSB/pixels"
|
|